这是描述信息
/
/
Air Tire Inflating Gun
Search
w6
w7

Air Tire Inflating Gun

• For use with any air compressor or direct air line
• Easy to read pressure gauge from 0-12 BAR
• Give an air tight seal
• Offset dual chuck allows easy access to all valves
• Female 1/4″ NPT air inflator provides user with easy and control inflation
w6
w7
Product description
Product Information

 

This is Air Tire Chuck Inflator Deflator Gun with Pressure Gauge. You must use the correct type and size of tool to suit the work, keep away from children. .

 

 

 

Product Parameters

 

Model

TRG18A

Min.Qty (Sets)

500

Body Treatment

PA 6 body

Packing

Double Blister

Qty/CTN (PC)

20

Meas(mm)

415X380X370 mm

N.W. / G.W.

12.0/14.0 kgs

Qty/20'FT

9560 PCS

 

 

Features

• For use with any air compressor or direct air line

• Easy to read pressure gauge from 0-12 BAR

 Give an air tight seal

 Offset dual chuck allows easy access to all valves

 Female 1/4″ NPT air inflator provides user with easy and control inflation

 

AIR TIRE INFLATING GUN 

"Recommended working pressure:0-4 bar

 working pressure:0-12 bar air inlet: 1/4""

Length of rubber hose: 44 cm"

 

Common Problems And Solutions

Maintain your equipment. It is recommended that the general condition of any equipment be examined before it is used. Keep your equipment in good repair by adopting a program of conscientious repair and maintenance. Have necessary repairs made by qualified service personnel.

Cleaning

If the moving parts of the equipment are obstructed, use cleaning solvent or another good degreaser to clean the equipment. Remove any existing rust, with a penetrating lubricant.

Do not use motor oil or grease to lubricate the equipment

Rust Prevention:

-Check daily for any signs of rust or corrosion.

Without a load lift the equipment as high as it goes and look under and behind the lifting points. If signs of rust are visible clean as needed.

Storing the Equipment

1. Store in a dry location, recommended indoors.

2. Equipment should be stored in an area where they will not be subjected to damage.

3. If extreme temperatures or chemically active or abrasive environments are involved, the guidance provided in shall be followed.

4. Temperature - When equipment is used at temperatures above 140"F (60"C) or below -20"F (-29"C), the equipment manufacturer or a qualified person should be consulted.

5. Chemically Active Environments -The strength and operation of eqipment can be affected by chemically active environments such as caustic or acid substances or fumes. The equipment manufacturer or a qualified person should be consulted before equipment are used in chemically active environments.

6. Other Environments - The internal workings of equipment can be affected by high moisture, gravel or sand, silt, grit, or other dust-laden air. Equipment subject to these environments should have their inner components frequently cleaned, inspected, and lubricated.

Note: If the equipment is stored outdoors, be sure to lubricate all parts before and after use to ensure the equipment stays in good working condition.

Scan the QR code to read on your phone
We could not find any corresponding parameters, please add them to the properties table
  • TOP