75 (1)
75 (7)
75 (6)
75 (5)

Pneumatic Oil Extractors

75 (1)
75 (7)
75 (6)
75 (5)
Product description

Product Information

This product for motor vehicles and motor cycles with level-gauge supplied with series of probes• Due to their versatility, these pantograph oil suction/drainers are universal drainers because they can be used to change the oil of all motor vehicles and motorcycles: - by gravity with tank on floor - by gravity with tank raised, with motor vehicles placed on auto lift or pit. - by suction with probe inserted directly in the engine, and anywhere because they do not require continuous connection to the compressed-air line or to other energy sources• (The oil must be hot 70/80°c).

Product Parameters



Product Size

545x510x970 mm

1#Package Size

540x520x1000 mm

2#Package Size

250x250x700 mm


22/26 kgs


5/6 kgs


105 PCS




Common Problems And Solutions

Maintain your equipment. It is recommended that the general condition of any equipment be examined before it is used. Keep your equipment in good repair by adopting a program of conscientious repair and maintenance. Have necessary repairs made by qualified service personnel.


If the moving parts of the equipment are obstructed, use cleaning solvent or another good degreaser to clean the equipment. Remove any existing rust, with a penetrating lubricant.

Do not use motor oil or grease to lubricate the equipment

Rust Prevention:

-Check daily for any signs of rust or corrosion.

Without a load lift the equipment as high as it goes and look under and behind the lifting points. If signs of rust are visible clean as needed.

Storing the Equipment

1. Store in a dry location, recommended indoors.

2. Equipment should be stored in an area where they will not be subjected to damage.

3. If extreme temperatures or chemically active or abrasive environments are involved, the guidance provided in shall be followed.

4. Temperature - When equipment is used at temperatures above 140"F (60"C) or below -20"F (-29"C), the equipment manufacturer or a qualified person should be consulted.

5. Chemically Active Environments -The strength and operation of eqipment can be affected by chemically active environments such as caustic or acid substances or fumes. The equipment manufacturer or a qualified person should be consulted before equipment are used in chemically active environments.

6. Other Environments - The internal workings of equipment can be affected by high moisture, gravel or sand, silt, grit, or other dust-laden air. Equipment subject to these environments should have their inner components frequently cleaned, inspected, and lubricated.

Note: If the equipment is stored outdoors, be sure to lubricate all parts before and after use to ensure the equipment stays in good working condition.


Scan the QR code to read on your phone
We could not find any corresponding parameters, please add them to the properties table
  • TOP