这是描述信息
/
/
Multilayer Bumpers Laying Stand
Search
sss46
sss47
sss48
sss49

Multilayer Bumpers Laying Stand

Made of galvanized sheet by laser cutting and edge curving,assembled with heavy duty PU universal wheels. Left and right sides can be extended freely.
Moving accident cars easily (front wheels and rear wheels damaged)Improving workshop utilization rate.
Material:6mm galvanized sheet, 6inches universal heavy duty wheels;
sss46
sss47
sss48
sss49
Product description

Product Information

 

 

Product Parameters

Model

TRX020001

Package Size

1230X300X190 mm

G.W./G.W.

31/32.7 kgs

   

 

Features

 

Common Problems And Solutions
Maintain your equipment. It is recommended that the general condition of any equipment be examined before it is used. Keep your equipment in good repair by adopting a program of conscientious repair and maintenance. Have necessary repairs made by qualified service personnel.

Cleaning

If the moving parts of the equipment are obstructed, use cleaning solvent or another good degreaser to clean the equipment. Remove any existing rust, with a penetrating lubricant.

Do not use motor oil or grease to lubricate the equipment

Rust Prevention:

-Check daily for any signs of rust or corrosion.

Without a load lift the equipment as high as it goes and look under and behind the lifting points. If signs of rust are visible clean as needed.

Storing the Equipment

1. Store in a dry location, recommended indoors.

2. Equipment should be stored in an area where they will not be subjected to damage.

3. If extreme temperatures or chemically active or abrasive environments are involved, the guidance provided in shall be followed.

4. Temperature - When equipment is used at temperatures above 140"F (60"C) or below -20"F (-29"C), the equipment manufacturer or a qualified person should be consulted.

5. Chemically Active Environments -The strength and operation of eqipment can be affected by chemically active environments such as caustic or acid substances or fumes. The equipment manufacturer or a qualified person should be consulted before equipment are used in chemically active environments.

6. Other Environments - The internal workings of equipment can be affected by high moisture, gravel or sand, silt, grit, or other dust-laden air. Equipment subject to these environments should have their inner components frequently cleaned, inspected, and lubricated.

Note: If the equipment is stored outdoors, be sure to lubricate all parts before and after use to ensure the equipment stays in good working condition.

 

Scan the QR code to read on your phone
We could not find any corresponding parameters, please add them to the properties table
  • TOP