这是描述信息
Search
20180122134332_337
20180122134355_439
20180122134357_836

8 TonHydraulic Pipe Bender

It can bend pipes up to an angle of 90° by using one of the included 6 precision cast dies.The heavy duty hydraulic ram applies a force of 12 tons to bend heavy gauge pipes up to a diameter of 2 inches. Its heavy duty gauge steel construction is long-lasting.
The bender has quick-change shoes for pipes other size diameter.
20180122134332_337
20180122134355_439
20180122134357_836
Product description
Product Information
This hydraulic tube rod pipe bender provides extra power for extra-large jobs. It can be used to bend gas, water, sprinkler or exhaust pipes, etc.

 

Product Parameters

Model

TRA0802

Capacity

8 Ton

Package Size

510x520x160 mm

N.W.

20 kgs

G.W.

21 kgs

QTY/20'CY

620 PCS

 
Features
 

It can bend pipes up to an angle of 90° by using one of the included 6 precision cast dies.The heavy duty hydraulic ram applies a force of 12 tons to bend heavy gauge pipes up to a diameter of 2 inches. Its heavy duty gauge steel construction is long-lasting.

The bender has quick-change shoes for pipes other size diameter.

 

Common Problems And Solutions

Maintain your equipment. It is recommended that the general condition of any equipment be examined before it is used. Keep your equipment in good repair by adopting a program of conscientious repair and maintenance. Have necessary repairs made by qualified service personnel.

Cleaning

If the moving parts of the equipment are obstructed, use cleaning solvent or another good degreaser to clean the equipment. Remove any existing rust, with a penetrating lubricant.

Do not use motor oil or grease to lubricate the equipment

Rust Prevention:

Check daily for any signs of rust or corrosion.

Without a load lift the equipment as high as it goes and look under and behind the lifting points. If signs of rust are visible clean as needed.

Storing the Equipment

1. Store in a dry location, recommended indoors.

2. Equipment should be stored in an area where they will not be subjected to damage.

3. If extreme temperatures or chemically active or abrasive environments are involved, the guidance provided in shall be followed.

4. Temperature - When equipment is used at temperatures above 140"F (60"C) or below -20"F (-29"C), the equipment manufacturer or a qualified person should be consulted.

5. Chemically Active Environments -The strength and operation of eqipment can be affected by chemically active environments such as caustic or acid substances or fumes. The equipment manufacturer or a qualified person should be consulted before equipment are used in chemically active environments.

6. Other Environments - The internal workings of equipment can be affected by high moisture, gravel or sand, silt, grit, or other dust-laden air. Equipment subject to these environments should have their inner components frequently cleaned, inspected, and lubricated.

Note: If the equipment is stored outdoors, be sure to lubricate all parts before and after use to ensure the equipment stays in good working condition.

 

Scan the QR code to read on your phone
We could not find any corresponding parameters, please add them to the properties table
  • TOP