这是描述信息
Search
20190502133946_355
20190502134019_268
20190502134019_766
20190502134020_912

Shortwave Infrared Curing Lamp

• Made from Aluminum alloy, 304 stainless steel mirror reflector and other special material.
• Applying to drying the painting work for spot damage from the car body, avoiding the heating up the whole spray booth which highly reduce the cost
• Suitable for drying the spot damage under one area of three panels.
• Unique electronic timer, digital control system for half-power or full-power optional; Each emitter can be independently controlled.
20190502133946_355
20190502134019_268
20190502134019_766
20190502134020_912
Product description

Product Information

Product Parameters

 

Type

TRSG1DS

Input Voltage

1PH110V/1PH220V

1#N.W. / G.W.

4/6 kgs

.

 

Package Size

485X445X265 mm

 

 

 

Features
• Made from Aluminum alloy, 304 stainless steel mirror reflector and other special material.
• Applying to drying the painting work for spot damage from the car body, avoiding the heating up the whole spray booth which highly reduce the cost
• Suitable for drying the spot damage under one area of three panels.
• Unique electronic timer, digital control system for half-power or full-power optional; Each emitter can be independently controlled.
 

Common Problems And Solutions
Maintain your equipment. It is recommended that the general condition of any equipment be examined before it is used. Keep your equipment in good repair by adopting a program of conscientious repair and maintenance. Have necessary repairs made by qualified service personnel.

Cleaning

If the moving parts of the equipment are obstructed, use cleaning solvent or another good degreaser to clean the equipment. Remove any existing rust, with a penetrating lubricant.

Do not use motor oil or grease to lubricate the equipment

Rust Prevention:

-Check daily for any signs of rust or corrosion.

Without a load lift the equipment as high as it goes and look under and behind the lifting points. If signs of rust are visible clean as needed.

Storing the Equipment

1. Store in a dry location, recommended indoors.

2. Equipment should be stored in an area where they will not be subjected to damage.

3. If extreme temperatures or chemically active or abrasive environments are involved, the guidance provided in shall be followed.

4. Temperature - When equipment is used at temperatures above 140"F (60"C) or below -20"F (-29"C), the equipment manufacturer or a qualified person should be consulted.

5. Chemically Active Environments -The strength and operation of eqipment can be affected by chemically active environments such as caustic or acid substances or fumes. The equipment manufacturer or a qualified person should be consulted before equipment are used in chemically active environments.

6. Other Environments - The internal workings of equipment can be affected by high moisture, gravel or sand, silt, grit, or other dust-laden air. Equipment subject to these environments should have their inner components frequently cleaned, inspected, and lubricated.

Note: If the equipment is stored outdoors, be sure to lubricate all parts before and after use to ensure the equipment stays in good working condition.

Scan the QR code to read on your phone
We could not find any corresponding parameters, please add them to the properties table
  • TOP